I didn't design it, but I'd like to try:
https://www.thingiverse.com/thing:126567
It's a 3d fractal made using code.
poofy_cat
joined 1 year ago
0.2 mm normal in prusaslicer. I scaled the model up 150%, which made some of the overhangs just a little too steep so there are a few small gaps near the top.
Transparent PETG, and it's about 10" tall.
A whole lot lol. Replaced and heavily modified the extruder, extruder motor, filament runout sensor, bowden tube, hot end cooling fan, and part cooling fan/blower. Also had to take apart the hot end / heat break and clean out leaked globs that had stuck everywhere. Also modified the electronics cooling/intake fan setup with a dc/dc converter and 12v fans to reduce noise.
I received a free broken CR-10S Pro V2 from my cousin, I finally have it repaired well enough to make these nice spiral vases. Here is the full album (not sure how to post albums here yet):
Extra poofy.
Cool, I didn't know about this.