I still don’t fully understand the benefit over plain WireGuard for a home lab use case…

I set up wg-easy (WireGuard socket container with built in web interface to easily generate certs for clients) in about 5 minutes on an odroid (like a raspberry pi). Opened a single port on my router. Generated certs for my phone and laptop using the web interface in about 30 seconds. Changed one line in my client configs to only route network on my home’s IP range over the VPN so I can connect without disrupting my internet connection. Then I just activate the VPN and I can access all of my home services. (writing all that out kind of makes it sound complicated but literally this was done in like 10 minutes total and never had to touch it again except to log into the web admin to make certs for new clients occasionally)

Since Tailscale is a mesh VPN like Nebula, wouldn’t I need to install and set it up on all of my servers and VMs instead of just one to access everything? And then every new VM I make I would have to manually set that up too? Wouldn’t that be harder to setup over all than a single wg-easy container?

I feel like maybe I don’t fully understand how Tailscale works because it never seemed more convenient or better than vanilla WireGuard and it just uses WG protocol under the hood anyway but with the added dependency of a 3rd party service I have to trust and that can go down disabling my access to my home network…