this post was submitted on 13 Sep 2024
923 points (98.2% liked)
People Twitter
5392 readers
398 users here now
People tweeting stuff. We allow tweets from anyone.
RULES:
- Mark NSFW content.
- No doxxing people.
- Must be a tweet or similar
- No bullying or international politcs
- Be excellent to each other.
- Provide an archived link to the tweet (or similar) being shown if it's a major figure or a politician.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
You're supposed to push the clutch fully to the floor when shifting. You should never grind gears unless you're about to money shift or something.
That could be the problem. I was told to shift when I felt the clutch take the power off the engine, and then give it a little gas when I feel the gears remesh. It was also on a 30 year old Peterbilt 5/10 speed hi/lo truck with everything worn out, so probably not the best thing to learn on
Yeah no, you're better off learning on a car. And just know that what you will do at the beginning is different from what experienced drivers do, as they'll have developed a "feeling" for the car that you don't have yet, so just do it by the book.
Learning on a transmission with >6 speeds is hard mode, they do take a little more thinking with the gear pattern than in a car. Synchro versions are not that hard if you're used to a regular manual but adding another thing to learn is not ideal when starting out. If it was a non-synchro variant then good luck getting someone to pick that up without a few solid hours of learning time.
If you were being taught by someone used to heavy trucks it makes sense why they didn't tell you to push the pedal right in - on many (all?) non synchro transmissions pushing the clutch all the way in brakes the input shaft and if you're moving you then have to resynchronise it with the gear speed in order to get into gear.
Note you don't actually have to push the clutch in all the way in a car either, all that really matters is getting it past the point where the clutch is fully disengaged. After all the clutch plate is either touching the flywheel to some degree or it's not touching, once it stops making contact pushing it further away doesn't make a difference. When first starting out though it's easier to just push the pedal all the way in - save thinking about finer details until you're comfortable with the basics.