this post was submitted on 17 Sep 2024
32 points (97.1% liked)
Woodworking
6215 readers
1 users here now
A handmade home for woodworkers and admirers of woodworkers. Our community icon is submitted by @1985MustangCobra@lemmy.ca whose father was inspired to start woodworking by Norm and the New Yankee Workshop.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
If you're not getting any flex in that aluminum, then it should be fine. MDF has its durability issues but as long as it's dry, it's ridiculously stable.
100% that aluminum is flexing, the question is how much matters to OP? A CNC router has far beefier extruded aluminum gantries but still flexes from the weight of the router, although typically less than a mil. My guess would be at least 10-15mil with the aluminum angle.
OP said about 1/16", which would be what? 50 or 60 mil? Honestly, though, it's woodworking. In the right context, like coarse slab flattening, 1/16" might be fine, though I would reckon that the point where fine tuning by other means is not that bad would be closer to 1/32".
Yes totally true, just saying that there will always be some amount of flex.
Thanks, it's only spanning about 36 in but there is about a 16th of deflection with my heavy duty router on board. I might shift the slab towards one of the weaker spots on my folding table because I figure the MDF will bend down there a bit and maybe I can match the slop in my rails with the slop in my table setup 🤣