this post was submitted on 29 Sep 2024
35 points (100.0% liked)
Linux
5032 readers
46 users here now
A community for everything relating to the linux operating system
Also check out !linux_memes@programming.dev
Original icon base courtesy of lewing@isc.tamu.edu and The GIMP
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I am on arch, using intel. It doesn't seem to like my 240fps display, since it's fine, when only connected to it, or my other displays, but crashes when connected to my all my displays at once.
What graphics card do you have?
Integrated Graphics i5-1340P
Hold up....
According to the specs on your CPU its max resolution is 4096x2304 @ 120Hz on an integrated flat panel. (Assuming you have a Laptop.)
Otherwise, on the HDMI and DPI output, the limit is 60hz. It can't run at 240Hz. It's like 4 times its max framerate for an external display!
Make sure your Wayland configuration is set up so that all your displays have the same framerate of 60Hz
If you want to have your display work at that framerate, you'll need to get a proper GPU.
Thats what I want to achieve.
Can you be more precise?
I want to force wayland to limit my fps to 60, but don't know how to do it, since wlr-randr doesn't work, because qtile crashes before reaching it in my autostart.sh.
Is Qtile installed alongside another DE? Maybe use the other DE just to configure your Wayland and switch back to Qtile after.
But again, Qtile still has issues with Wayland, so maybe either don't use Qtile or don't use Wayland. Pick one.