this post was submitted on 11 Nov 2024
984 points (98.3% liked)
Programming Humor
2681 readers
1 users here now
Related Communities !programmerhumor@lemmy.ml !programmer_humor@programming.dev !programmerhumor@kbin.social !programming_horror@programming.dev
Other Programming Communities !programming@beehaw.org !programming@programming.dev !programming@lemmy.ml !programming@kbin.social !learn_programming@programming.dev !functional_programming@programming.dev !embedded_prog@lemmy.ml
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
MasterCAM blows absolutely every open-source solution out of the water. It isn't even a competition. In this case, it is actually cheaper to buy their really expensive and restrictive license, because in the end you save a near immeasurable amount of time in modeling, drafting, programming, and production. The fee CAD programs that can even support a postprocessing operation (becoming closer to a real CAM solution) are really bad at it and the toolpaths are far from ideal.
That sounds really specific.
It is, but MasterCAM is also the primary workhorse for a large global industry, so I wouldn't say that it is insignificant by any means.