Soap Making

175 readers

9 users here now

Do you make soap? Talk about it!

founded 2 years ago

MODERATORS

itsworkthatwedo@sh.itjust.works

Custom soap mold from hobby clay (lemmy.world)

submitted 2 days ago by Deestan@lemmy.world to c/soapmaking@sh.itjust.works

11 comments fedilink hide all child comments

Just for fun!

Made a shape out of gray self-drying hobby clay, took a (very clumsy) silicon mold of it, and now I have a fun shape to pour excess soap into if I make too much for the main mold.

On the left: clay thing. On the right: lavender soap.

you are viewing a single comment's thread
view the rest of the comments

[–] SubArcticTundra@lemmy.ml 2 points 2 days ago (3 children)

I have a question — is there any way to smoothe out the grooves made by the 3d printing prpcess? Is there any good site I can look at that catalogs these techniques?

[–] merde@sh.itjust.works 8 points 2 days ago (2 children)

nothing in that photo is 3d printed

[–] shalafi@lemmy.world 3 points 2 days ago

OP meant, "if I made a 3d printed mold for soap". Didn't seem completely stated.

[–] SubArcticTundra@lemmy.ml 2 points 2 days ago

Oh, whoops

[–] AnotherMadHatter@lemmy.world 5 points 2 days ago

You could spray paint the printed model with sandable primer. Then you can sand and spray it repeatedly until you get the finish you are looking for.

[–] Deestan@lemmy.world 1 points 1 day ago

The lines are from sandpaper when I flattened and sharpened the edges :)

Only had very coarse sandpaper lying around. Finer paper would make it smoother.