78

I've only bought the pan a week ago and used it three times. Hot dogs, eggs, and steak.

When I'm done I clean it with a scrubby sponge and once with a little bit of detergent, then put it on the stove to dry quickly. Then while it's hot I smear maybe a teaspoon of vegetable oil on it with a paper towel "brush".

In between uses it's wet with oil, as you can see in the picture. How much residual oil should there be? I had the impression that it would be dryer.

Also, how much should I scrub? I am not going to leave crust of beef on there, but I also don't think it's supposed to be scrubbed back to new smoothness.

you are viewing a single comment's thread
view the rest of the comments
[-] athairmor@lemmy.world 8 points 1 year ago

While the type of oil isn’t critical, I would use something with a higher flash point and less flavor than olive oil.

Peanut, canola or vegetable oil are my preferred oils for seasoning.

this post was submitted on 23 May 2025
78 points (100.0% liked)

Cast Iron

2720 readers
1 users here now

A community for cast iron cookware. Recipes, care, restoration, identification, etc.

Rules: Be helpful when you can, be respectful always, and keep cooking bacon.

More rules may come as the community grows, but for now, I'll remove spam or anything obviously mean-spirited, and leave it at that.

Related Communities: !forgediron@lemmy.world !sourdough@lemmy.world !cooking@lemmy.world

founded 3 years ago
MODERATORS