756
Are you being ripped off? Good luck!
(lemmy.nz)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 20 Nov 2025
756 points (98.8% liked)
People Twitter
10483 readers
930 users here now
People tweeting stuff. We allow tweets from anyone.
RULES:
- Mark NSFW content.
- No doxxing people.
- Must be a pic of the tweet or similar. No direct links to the tweet.
- No international politcs
- Be excellent to each other.
- Provide an archived link to the tweet (or similar) being shown if it's a major celebrity, figure or any politician
- https://www.sotwe.com/
- https://twitterviewer.net/Note: Archive.is is no longer recommended because they remove/alter content.
- If a tweet (or similar) makes a statement of fact, either mark it as "satire" in the body or provide the original source link backing up the statement (see rule 6)
founded 3 years ago
MODERATORS
How tf should this work? The holder doesn’t get any wider just by inserting a different roll holder pin
Wider? No. It allows a girthier roll by moving the center away from the inside edge.
It's extending the distance from the wall. We got one for free at the grocery store when they first promoted this. We don't regularly use it, but it did work when we tried it out.
They're not taller (where height is the height of the cylinder), their diameter is larger. Since holders have the pin a fixed distance from the wall, this extension gives a few centimeters extra between the pin and the wall, allowing for the extra diameter