this post was submitted on 23 Aug 2023
178 points (99.4% liked)

Bicycles

3125 readers
26 users here now

Welcome to !bicycles@lemmy.ca

A place to share our love of all things with two wheels and pedals. This is an inclusive, non-judgemental community. All types of cyclists are accepted here; whether you're a commuter, a roadie, a MTB enthusiast, a fixie freak, a crusty xbiking hoarder, in the middle of an epic across-the-world bicycle tour, or any other type of cyclist!


Community Rules


Other cycling-related communities

founded 1 year ago
MODERATORS
 

I didn't even need to bring front panniers, or a rear basket in place of my trunk bag ๐Ÿคญ

The trailer is a Wike City Cargo.

you are viewing a single comment's thread
view the rest of the comments
[โ€“] Rivalarrival@lemmy.today 3 points 1 year ago (1 children)

Trailers are awesome. Getting all that weight off the bike makes a huge difference in handling.

I don't know what yours is rated to, but so long as you balance the load well, you can haul 400+ pounds in a trailer.

[โ€“] Showroom7561@lemmy.ca 4 points 1 year ago (1 children)

I believe this one is 100lbs rated, but some that I've seen can carry a lot more. It's impressive what a bike can move!

[โ€“] Rivalarrival@lemmy.today 1 points 1 year ago (1 children)

Yeah, the lowest gear ratios of mountain and touring bikes give you enough torque to haul several hundred pounds.

I had a similar trailer. I ended up ripping off all the canvas and screwing a plywood deck to the frame. I had 400 pounds of water softener salt on it with no problems.

Extending the towbar about 8 feet, I used to tow a canoe.

[โ€“] Showroom7561@lemmy.ca 2 points 1 year ago (1 children)

I ended up ripping off all the canvas and screwing a plywood deck to the frame. I had 400 pounds of water softener salt on it with no problems.

Yeah, the soft plastic they use has got to go. Plywood sounds like a nice upgrade!

Did you ever need to upgrade the tires/tubes to hold 400 lbs??? I think I may pick up some Schwalbe Marathons, for their puncture resistance and weight carrying capacity. They've got them in 16" sizes :)

[โ€“] Rivalarrival@lemmy.today 2 points 1 year ago* (last edited 1 year ago) (1 children)

Did you ever need to upgrade the tires/tubes to hold 400 lbs??

Not the tires and tubes, no. Just overinflated them a little. I was concerned about the rims and spokes, but they seemed like they were reasonably beefy. I didn't plan on doing any jumps or stunts with the trailer, so I was reasonably confident at low speeds.

If I were to do it again, I would have started with a trailer with forked wheel mounts. On mine, the axle inserted into a quick release bracket from the side. I think yours do the same thing. They flexed a little more than I liked; they would have been the weak point if I loaded mine any heavier. Something like this would be inherently stronger:

The axle is attached on both sides of the wheel, just like the axles on your bike. A little more difficult to install and remove, but not too bad.

[โ€“] Showroom7561@lemmy.ca 1 points 1 year ago

Mine are also quick release, so I can understand how they aren't the most robust. But smaller wheels = better strength and less of a chance of spokes busting under load. The tires that came on my trailer are cheap, so I might not wait until they go before replacing them. Not sure what kind of tubes they have, but I don't mind replacing those with the tires. LOL The last thing I want is to carry 100lbs with a flat on the trailer.