I got the ZBT-2 and there is very little setup or instruction involved.

Plugged in its one and only cable to my pi5. It installed open border thread integration and matter integration.

It flashes blue seemingly at random.

I cannot get any of the IKEA Myggbett, Bilresa or whatever the sockets are called to connect.

I am sat at my ZBT-2, connected to Pi via USB C. Pi is on LAN. I am on wifi.

I get one of two failures

1 unable to connect, check device, reset, check pairing mode etc.

2 setup requires an open border thread controller and then I check and the integration is bugging out.

Please tell me where I am being an idiot