199
A brick has been shat
(lemmy.nz)
As an atheist, I ask for prayers that the backup's good.
E: Your solidarity has worked. The backup is good and not too old. Note for myself and you - install your OS on a snapshotting filesystem so that live backups are possible.
Thats a good advice, for that to work you just need to remove the solder, reball the memory ic and solder back if there are no broken/ripped pads. If there are any ripped pad then still can be done but you need an expert at microsoldering to rebuild the tracks
Yea i would guess the pads are ripped i have never seen the solder breaking instead of the pads ripping. If that happend to someone near me i would try to fix it since it isnt imposssible if you have some experience and a microscope but not sure if your average repairshop can do that.
I do see one potentially ripped pad on there (top right). The rest seem like they should be fine.
Hard to tell with the image quality though. I’d definitely give it a shot regardless, spend a few bucks to save potentially many times more. Especially in this economy.
I dont think thats a ripped pad. Right(middle to botton) side of the chip whatsoever... Those are ripped 100%. You can still see part of the trace too
how exactly can you tell? just curious
Those thingies sticking out are like part of the traces. It can be solder, but that looks very sus and with the brown shade i assume its the back of a trace hehe
EDIT: and i just noticed there is a fitting mark on the other side. So very very likely ripped traces. And the more i look at it the more i think thats more ripped traces then alive ones haha
So expensive data recovery solder op if something critical was on it.
50:50 unsolder and transplant all the chips onto a fresh nvme pcb or try to solder jumpers to the traces/pads to the chip long enough to get a data export.