submitted 2 days ago by Squizzy@lemmy.world to c/homeassistant@lemmy.world

6 comments fedilink hide all child comments

I want to leave HAOS live and also run docker for an arr stack sparately.

I got a good deal on a pi5 16gb. I wont get another and NUCs are expensive. I want to put an arr stack, deluge and Jellyfin for local single device viewing. I don't see HA using more than 6gb of RAM, or close to it, so tere should be room to manage this.

I have a 256gb sd, I will change eventually to ssd, so I think I have the resources.

I just need the know how, could anyone advise on some walkthroughs that could allow me to not knock HA while I build out the other side.

you are viewing a single comment's thread
view the rest of the comments

[-] CameronDev@programming.dev 1 points 2 days ago

To add on, the supervisor install was a terrible experience, I did it for years. Constant issues updating, very broken experience.

this post was submitted on 30 Sep 2026

13 points (100.0% liked)

homeassistant

20718 readers

203 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 3 years ago

MODERATORS

GreatAlbatross@feddit.uk

greatalbatross@lemmy.world