196

OH İTS THE FUCKİNG LOSS COMİC

All I know is, 7 is leaking out.

1. 5 which begins to overflow into the room
2. 7
3. 4 and 6
4. 2 and 3
5. 1

This is assuming this is a cross section of something 3d and not something 2d otherwise air packets would get trapped and prevent some of this.

5, but it also depends on the circumstances. What liquid is used, temperature, viscosity, etc. There's some material science stuff that's far beyond the intended scope of this question.

They are all full already, of air.

Depends on how much you turn on the tap. If you fürn it up completely its 1,else its 5.

5

Also, you suck.

I wish these were drawn as closed containers

I hate you so much right now. Also I think it's 5

None. The water is not running.

Unless I completely misunderstand how this works, I think 5 is the only one that will fill up. It then overflows, preventing any of the taller ones from filling. 7 is shallower but won't start filling until 3 gets fuller than 5, which it never will. This would be true whether the blockage between 2 and 3 is a mistake or not.

5 will be the only one that will ever fill up unless you really crank up the pressure in which case 7 will also fill but very slowly. 5 and 7 are open containers and there's a hole in the bottom of 4. But if it's water coming out of a tap then only 5 will fill .

5

Wait... Fuck!

5

All of them are already full of air.

1 fills up first. the spigot is much winder than the tube so the glass will fill faster than it can drain.

Also rule

1

I actually started to figure out the sequence...then I realized...fuck you, take my up vote

Wouldn't scale and viscosity play a role? Seriously, imagine a river vs a capillary tube. Also how many dimensions? And forces involved? Is that a blockage between 2 and 3? Are the walls breakable? How will the fluid hold air? Are the lines into structure 5 lower than the walls? Is this in a vacuum?

This diagram scratches my brain real good, especially thinking about it getting filled