As long as you didn't have to put a bunch of torque on it or your bolts were not exceptionally Chinese it'll probably be fine.
Where are you off too? Stop by if you need anything done to your bike on the way.
California to Virginia
Yeah its a Suzuki 8R, they were caliper (mounting?) bolts when I replaced rear brake pads so....there was a bit of torque but I dont think I ruined them lol.
Awesome. That's a long one.
Last time I used the wrong tool it was a t25 in a t27 and then had to spend a few hours with a drill fucking things up.
I dont do a lot of maintenance these days but I always wonder why tf use this or that niche bolt head like Torx or flat head when theres no angle to reach it or some aircraft bolt heads like T20 is so small there always being stripped. Hey let's put a hex head that is facing the earth in a tight panel surrounded by exposed wires and electrical posts such that you cant use a hex socket and need to use the L shaped Hex tool and so can only turn it 1/20th a turn before removing and repositioning ahhhhh
Just post something ๐
Lemmy's general purpose discussion community with no specific topic.
Sitewide lemmy.world rules apply here.
Additionally, this is a no AI content community. We are here for human interaction, not AI slop! Posts or comments flagged as AI generated will be removed.