31

top 6 comments
sorted by: hot top new old
[-] Kratzkopf@discuss.tchncs.de 6 points 3 years ago

What does "petting" mean in this context?

[-] Scafir@discuss.tchncs.de 2 points 3 years ago

The little gray wires should be all nice and straight. Even though your chip may be a good boi, touching it will wreak havoc on the wire bonding. Repairing the damage shown on the picture takes a skilled worker and very expensive equipment. Even then the repair is not fully guaranteed to be successful.

[-] Krististrasza@lemmy.world 1 points 3 years ago

Any touch is a bad touch.

[-] nothacking@discuss.tchncs.de 5 points 3 years ago

Why is the chip naked? Get a can or some epoxy.

[-] Scafir@discuss.tchncs.de 7 points 3 years ago

We are working towards having a product properly packaged. This is a prototype that is not mature enough yet to justify the cost/time to package it. Moreover, this custom chip is used to measure ultra low currents (down to femto amps), so any packaging could potentially interfere with the measurement capabilities (-> no epoxy). It is however protected by a large shielding box, but it's no use during assembly/modifications :/

[-] xoggy@programming.dev 1 points 3 years ago

Advice considered.

this post was submitted on 25 Jul 2023
31 points (100.0% liked)

Electronics

2963 readers
1 users here now

Projects, pictures, industry discussions and news about electronic engineering & component-level electronic circuits.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: No circuit design repair, tools or component use / sourcing questions. Those go in ASKElectronics.

5: No excessively promoting your own sites, social media, videos etc.


Ask questions in https://discuss.tchncs.de/c/askelectronics


founded 3 years ago
MODERATORS