A friend gave me this Prusa MK3S+ a few years ago and it came inside a set of Besta storage cabinets, 2x 40cm deep ones. Its was always a bit unwieldy in my small apartment and since it was on the ground, I have to always bend down to do anything.
I'd been searching for decent options for a while and it seemed like the cabinet I really wanted was only available at IKEA USA. I'm in Canada so I decided to get a bit creative.
This cabinet is 60cm deep and 2 units tall. I joined a 20cm and 40cm Besta for both levels, but offset the joint. Top is 20+40, bottom is 40+20 (when looking from the front). That really helped with rigidity and then adding some plates across joints at top and bottom.
The side vents to the window, which, if I'd measured right the first time would have been 1 hole instead of 2, but its not visible so, meh.
I'm incredibly happy with how this turned out. My next step is a rubber pad to sit the printer on and then adding so of the vehicle sounds dampener to it as I've seen someone else do. Though, truthfully, even the cut up yoga mat under it has made a massive difference.
Wire brush bristles can come off, stick to a grill, transfer to your steak, and best case scenario stab you in the mouth... Ask me how I know. Worst case you intestine.
Stick to the biodegradable fibre ones, or this seems like and ok option.
But for the love of god, do not use a wire brush.