I can see both under (gaps between lines) and over (at the edges of the first layer) extrusion in that photo, so i think it's likely one of orca's calibration settings. Does it still happen if you use completely stock settings in bambu slicer? If so, I'd go back to defaults in orca then start tweaking again from there.

anyone know of a qmk mouse board that's smaller than ploopy?

Well done, this should be law and apps like Uber should have to turn off their tip screens to operate here.

Fairly sure this is a regression in the current release, i just ran into the same thing after upgrading to 1.34 and went back to 1.31.1