And the terrorist fist jab!
qwertilliopasd
I think I know precisely what you mean
The Donner party were a group on the Oregon trail that got stuck on a mountain pass in the winter and resorted to cannibalism to survive. The Dollup did a really good podcast episode about it.
Also the cafe in the University of Colorado UMC is named "The Alfred Packer Gill". Alfred Packer was a similar famed cannibal.
Abortions for some, miniature American flags for others!
Madonna had to show up unannounced to one of their houses and beg to get the green light for the sample in hung up. While I really enjoy the growing list of artists telling trump to kick rocks, ABBA is not at all surprising.
looks like the female end of a crimp on bullet connector
I'm glad they can make a joke that's not just "_____ identifies as _____"
They are typical as low-point drains and manifold drains, both on the main line (always charged). Don't just cap it if that would make a dead end, especially if it's sloped down to drain. I can't tell very well from the picture, but if it's on a tee you would be okay putting in a threaded cap.
"king drains" or auto drains are common. A short nipple and either a brass cross-top or pvc ball valve would be better. Just be sure that it is accessible in the end.
That soundtrack still slaps.
A thin layer of glue stick kept petg from bonding to glass for me, but a nice thick layer of G10 is better as long as you heat soak it before printing. I roughed mine up with some sandpaper and haven't had any issues. Just remember good ppe when working with fiberglass.