99
Errr... IDK embrace the jank?
(lemmy.nz)
it's a portable monitor and can't be mount on generic stand
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 02 Oct 2025
99 points (99.0% liked)
Battlestations
2675 readers
1 users here now
Welcome to /c/Battlestations
A community for sharing your computer, gaming or work setups as well as discussion about anything related to such setups.
- Posts should include a photo of a computer setup of some kind or be a discussion of computer setups.
- Posts or comments that are homophobic, transphobic, racist, sexist, ableist, or advocating violence will be removed.
- Be civil: disagreements happen, but that doesn’t provide the right to personally insult others.
- Spam, self promotion, trolling, and bots are not allowed
founded 3 years ago
MODERATORS
This problem is perfect for 3D printing. Just measure the mounting hole locations and print out a simple stand. Use something that isn't PLA as the material though due to its tendency to warp when heat is applied under a physical load.