31
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 12 Dec 2025
31 points (100.0% liked)
3DPrinting
23622 readers
95 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![]()
Moderation policy: Light, mostly invisible
founded 3 years ago
MODERATORS
How would I go about putting them together? With super glue?
I'd start with superglue, also @pixeltree@lemmy.blahaj.zone makes a very good point. Creating some aligned holes and pins would make the assembly much more exact. I did something like this when I edited this model to fit on my previous printer. Slice the model and while it's aligned in whatever editor you are using, create a 3mm diameter pocket which goes 5mm deep in each side in three places, creating a triangle of pockets. Then print some pins which just fit those holes. This will ensure everything lines up nicely. Once printed and glued, you can use a filler putty like Bondo to fill any gaps. Then sand and paint.
That, but I'd also probably put some pins in to make it exact
A heat gun to weld the filiament together. Superglue actually sucks at bonding a lot of filaments.
Works great for pla though.