DIY

4332 readers

224 users here now

Share your self-made stuff and half-baked projects here.

Also check out !diy@beehaw.org

There is also a related XMPP chat.

founded 4 years ago

MODERATORS

poVoq@slrpnk.net

livligkinkajou@slrpnk.net

149

Figured something out today that in hindsight seems rather obvious (lemmy.nz)

submitted 8 hours ago by Iconoclast@feddit.uk to c/diy@slrpnk.net

24 comments fedilink hide all child comments

Even with perfect measurements it's impossible to get to that line straight unless the frame is perfectly square. This not only completely solves that issue but also saves a ton of time not having to measure and cut them one by one.

Also the lumber I picked turned out to be 10 cm longer than the deck and I even picked the exact right amount. By the time I was done I only had a basket of <10 cm off-cuts.

you are viewing a single comment's thread
view the rest of the comments

[–] bluGill@fedia.io 21 points 6 hours ago (1 children)

Circular saw with the blade set such that it just barely will cut all the way through.

[–] 4am@lemmy.zip 2 points 2 hours ago (1 children)

Shouldn’t you set it about 1/4” below whatever you’re cutting?

[–] bluGill@fedia.io 2 points 2 hours ago

Depends but i would say quarter is way too much. Generally dimensioned lumber is close enough that right on is just fine but rough cut needs more tolerance. My habit was often a 32 less and the rest breaks off with no danger to the blade.