this post was submitted on 27 Jul 2026
47 points (94.3% liked)

Australia

5087 readers
91 users here now

A place to discuss Australia and important Australian issues.

Before you post:

If you're posting anything related to:

If you're posting Australian News (not opinion or discussion pieces) post it to Australian News

Rules

This community is run under the rules of aussie.zone. In addition to those rules:

Banner Photo

Congratulations to @Tau@aussie.zone who had the most upvoted submission to our banner photo competition

Recommended and Related Communities

Be sure to check out and subscribe to our related communities on aussie.zone:

Plus other communities for sport and major cities.

https://aussie.zone/communities

Moderation

Since Kbin doesn't show Lemmy Moderators, I'll list them here. Also note that Kbin does not distinguish moderator comments.

Additionally, we have our instance admins: @lodion@aussie.zone and @Nath@aussie.zone

founded 3 years ago
MODERATORS
 

From January 1 2026, ... all new cars sold in China will need handles that can be manually opened in an emergency, even when a car has lost power. The US is currently considering a similar move.

The ban followed a series of sometimes fatal incidents, where people were trapped inside burning, flooded or frozen cars, with doors unable to be opened from the outside.

Australia risks becoming a “dumping” ground for electric cars following the introduction of new Chinese safety rules from next year, a report for Australian car dealers has warned.

The Australian Automotive Dealers’ Association – which represents 3,900 new car and truck dealers – recently released an independent report by legal expert Emeritus Professor Jenny Buchan.

It largely focused on problems with drivers getting car repairs done under Australian consumer law. But the report also concluded:

Australia should not ignore the risk of stock dumping following China’s approach to EVs with flush door handles. The US has also recognised the problems flush door handles cause and responded by introducing a bill to the House of Representatives.

...

Web Archive link

you are viewing a single comment's thread
view the rest of the comments
[–] Salvo@aussie.zone 1 points 14 hours ago

If I was a manufacturer, I would do is look though my parts catalogue for recessed door handles with an integrated trim.

I would also create cutting templates for the door skin and stick-on mounting brackets for the one-piece door handles.

Dealer Technicians would have instructions to remove all the retracting crap, tape the template to the skin, and cut out a hole. Then they would epoxy the mounting brackets inside the door shell. This will enable them to install the old-design handles.

I would recall and cancel the retracting door handles. When stock of the retracting-handle-compatible door skins are depleted, I would supersede the doors to a new, safer design plus the new, safer handles.