3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![]()
Moderation policy: Light, mostly invisible
view the rest of the comments
I think your effort would be better put towards an enclosure for the whole printer if you don't already have one.The radiant heat loss of the bed will become a good thing. Lots of people add additional heat time to give the stagnant air time to heat up the enclosure. As others have said though it sorta depends on what you're printing mostly if it matters at all. PLA is such low temp it's not difficult for the machine to maintain at all. If you're doing PC or nylon you may need every advantage you can get.
For the adhesives conversation, there are quite a few that can cope with high temp. Silicone is probably the best in case you regret it. Other glue could take a coating of your plate off.