this post was submitted on 21 Sep 2023
34 points (100.0% liked)

3DPrinting

15763 readers
34 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or !functionalprint@fedia.io

There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml

Rules

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago
MODERATORS
 

Prusa dun good with this surprise update.

Modified MINI: Revo hotend + Bondtech extruder

Side notes (will add more as I test this firmware):

  • The pre-sliced benchy from Prusa is a bit of a hack. While it does showcase the new speeds, you are not going to get the best performance when you slice it in Prusa Slicer. The new printer profile is good, but it is absolutely in alpha. (I amended a comment below where I was moving all settings to max.)

  • Factory Prusa profile for IS, only uses 0.4mm nozzles (I have been using 0.6mm nozzles exclusively for a while now)

  • If your belts are still stock, order new ones now. The stress that is getting put on the belts now is a little more extreme. (FYI: There was an error in the F1 x-gantry stop where it might wear the belt excessively, so look close.)

  • I have properly packed all the bearings in the printer with grease so they are not as noisy as they would be stock. Be prepared for bearing noise, is what I am saying.

  • Faster printing is causing ~-2°C drift on my REVO nozzle. That is expected and might be able to PID tune for better stability. It's not bad, just something of note.

  • "BonkersBenchy" was sliced with Prusa 2.6.2a. and accelerations are set at 8000mm/s^2. There are other subtle changes in the gcode that affect total print speeds, so dig into them if you need mor fasts.

  • The printer compensates OK when the print speed is manually set to 255 (absolute max). Your top layer bridges are going to have a rough time. It may work or, your print will be ripped off the bed because the first top layers aren't exactly studio quality. (I should say it adjusts to max speed better than it did with older firmware.)

you are viewing a single comment's thread
view the rest of the comments
[–] Contend6248@feddit.de 2 points 1 year ago* (last edited 1 year ago) (1 children)

I'm wondering, how are you dialing in customized, (in your case hot-end and extruder) printers with input shaping?

Is it something working for any device and any combination of parts, if the computational part supports it?

[–] remotelove@lemmy.ca 2 points 1 year ago* (last edited 1 year ago)

It's all factory settings in this case. I am running my own print now with the new Prusa Slicer 2.6.1 profile. So, nothing is dialed in yet. (Edit: I am using Voxel PLA Pro which can use the Prusament filament profiles.)

There are options to tweak the input shaping in the printer menu but I haven't played with them yet.

I find it very odd that the factory sliced gcode for the benchy even worked with my printer mods. The input shaping is supposed to be for the stock MINI, but it works fine for my printer. (That boggles my mind as that breaks how I think of mechanical resonance.)