Transcription: a photo of a shared pathway entrance with a series of steel pipes placed to create very narrow pathways to enter. The width is hard to tell from the angle of the photo, but far too narrow for a wheelchair or bicycle to fit.
this post was submitted on 10 May 2024
45 points (100.0% liked)
Aotearoa / New Zealand
1658 readers
16 users here now
Kia ora and welcome to !newzealand, a place to share and discuss anything about Aotearoa in general
- For politics , please use !politics@lemmy.nz
- Shitposts, circlejerks, memes, and non-NZ topics belong in !offtopic@lemmy.nz
- If you need help using Lemmy.nz, go to !support@lemmy.nz
- NZ regional and special interest communities
Rules:
FAQ ~ NZ Community List ~ Join Matrix chatroom
Banner image by Bernard Spragg
Got an idea for next month's banner?
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
It's a very common design on shared walking/cycleways. A bike will fit through the middle, they are pretty skinny. And the one in the OP isn't finished, then will fence up to the sides so you have to go through it.
The bit I was worried about is that it looks roughly the right height that the handlebars might hit the narrower top part.
Nah most bikes are much higher than those rails. If a bike isn't (like a kids bike), they can go under the rails on the sides since there's a sufficient height difference.