this post was submitted on 15 Jul 2023
9 points (100.0% liked)

leathercraft

424 readers
2 users here now

a place for makers and creators - whether business or side hustle or hobby.

founded 1 year ago
MODERATORS
bowreality@lemmy.ca
9
Proof of concept pricking iron (self.leathercraft)
submitted 1 year ago by Lemmyin to c/leathercraft@lemmy.ca
2 comments fedilink hide all child comments
 

Made a pricking iron from a bit of copper bus bar I had. I ordered a bunch of 250/27LP sewing machine needles.

2.5mm holes drilled and it’s a perfect fit for the needles. Started off nicely but got caught by drilling copper too fast. Just bound up and broke a drill in the hole. Ffs. Dropped the drill press RPM down to 580 and that worked well.

I will now make a single awl using one of these needles, and a double and quad pricking iron.

https://imgur.com/a/uooMjll

you are viewing a single comment's thread
view the rest of the comments
[–] Lemmyin 2 points 1 year ago

Very snug fit and then soldered in place.

Just made a 4 needle one today. Everything was great until I discovered that the copper block shifted very slightly while drilling hole number 3. I guess I will try again at some point. Grr. Hehe. Good things take time I guess 🤣