Always bagel.

You should include the printer and slicer you use in your post.

Agreed. I initially used AUR since native builds tend to work better but after that whole debacle with malware (thankfully I wasn't affected) I've removed all except a select few and just replaced everything I could with flatpaks. Takes a bit of tweaking for some apps but honestly worth it for peace of mind.

What you're saying is false though.

You can read about what kernel SteamOS is using. The kernel itself is only like ~150MB, there isn't really a need to slim it down. I think, if anything, Valve contributes to the mainline kernel for linux.

Proton is the "fine-tuning", the OS is just Arch Linux with a paint job.

That is not the smoking gun you think it is.

Again... SteamOS is just an immutable version of Arch Linux. That's what they are talking about in the article when they talk about turning off "read-only" mode. Being immutable makes it less likely to break/more stable, but doesn't "fine-tune" it for gaming.

Saying it's "fine-tuned" for gaming takes away from what is actually doing the heavy lifting for gaming on linux, which is Proton. One could argue Proton is "fine-tuned" WINE, but SteamOS is not "fine-tuned" for gaming.

It's arch, so no. The hardware that utilizes the OS is fine tuned to be used with a controller, since a controller is literally built into it.

Proton is the fine tuned bit, but that runs on many distros.

I'm a basic American and just drink Lipton black tea. I have had PG Tips and liked it but the grocery store near me doesn't carry it anymore 😟.

Commenting to save for later, thanks!

I'm not alone! Been a dev for almost 10 years and every time I declare and initialize a dictionary I either have to Google it or stare at it for a minute to realize what I'm doing wrong 😂 I blame JSON.

That's for this. Will definitely be watching over the course of the next few weeks.

Sure thing, I have a two Sovol SV06's, one for a 0.4 nozzle and one for a 0.2 nozzle, and a Bambu Labs X1C.

The SV06's took me a few weeks to tweak, especially the one with the 0.2 nozzle.

Here is my cura profile for the Sovol SV06 with the 0.4 nozzle https://filebin.net/ljh52w2lehipzbms

Just using that outright probably won't work. What I would do is load up the default Ender 6 profile that Cura has, and then adjust settings based on mine. For instance. You went from a bowden extruder to a direct drive. So you can probably copy my retraction settings as a baseline and adjust from there. You need far less retraction on direct drive extruders (i.e. 0.2mm-1mm for direct drive vs 5mm-8mm for bowden).

I would also look up CHEP and Teaching Tech on youtube. They have great videos on bed leveling and everything else related to 3d printing.

What printer? If you have a glass bed, glue stick like the other guy said.. if you have a textured pei sheet, clean the sheet with 99% isopropyl alcohol.

Actually any time you touch the bed with your hands, no matter if it's glass or pei, clean it with 99% isopropyl alcohol. The oils on your hands are the enemy of good bed adhesion.