this post was submitted on 10 May 2024
45 points (100.0% liked)

Aotearoa / New Zealand

1658 readers
16 users here now

Kia ora and welcome to !newzealand, a place to share and discuss anything about Aotearoa in general

Rules:

FAQ ~ NZ Community List ~ Join Matrix chatroom

 

Banner image by Bernard Spragg

Got an idea for next month's banner?

founded 1 year ago
MODERATORS
 

Transcription: a photo of a shared pathway entrance with a series of steel pipes placed to create very narrow pathways to enter. The width is hard to tell from the angle of the photo, but far too narrow for a wheelchair or bicycle to fit.

you are viewing a single comment's thread
view the rest of the comments
[–] Zagorath@aussie.zone 24 points 6 months ago (2 children)

Supposedly it's to keep motorbikes out.

But when your design also forces bikes to be lifted up, cuts out wheelchairs and even fat people...it's astonishing to me that any government department could think this was OK.

[–] herescunty@lemmy.world 11 points 6 months ago* (last edited 6 months ago) (1 children)

Motorbikes will 100% go round via that patch of dirt next to it.

~~I reckon (could be way wrong) that you could get a bicycle through by turning the handlebars 90 degrees in either direction so they slip through the thin bit and the bit at the bottom is wider so the wheel could go through as long as you lift it and roll the bike on its back wheel. Thats still really rubbish if that’s the design tho.~~ edit: nevermind, I was looking at it wrong. I don’t think that works.

I doubt a wheelchair is getting through there anyway anyhow.

[–] Zagorath@aussie.zone 4 points 6 months ago

Apparently it's not finished yet and they might end up fencing it off to prevent going around in the dirt.

[–] Longpork3 6 points 6 months ago (1 children)

If it's tp keep motorbikes out then it has failed anyway because it stops at the edge of the path, and leaves plenty of room to drive a motorbike around.

[–] Dave 2 points 6 months ago

They haven't finished. It will be fenced to the edges.